About Blackmagic Cintel Software

The Blackmagic Cintel Scanner allows capture of 16 and 35mm film. This software will install the software required to support the Cintel Scanner as well as installing software to support the optional Cintel Audio and KeyKode Reader. Once installed, you can use DaVinci Resolve to operate your Cintel Scanner, or any software that supports the Cintel Scanner developer SDK.

If your Cintel Scanner requires an internal Firmware update, then the Cintel software will allow this to be updated via the included Cintel Setup utility.

What's new in Cintel 4.0

• Adds support for new Cintel Scanner with capstans.
• Cintel now has it's own installer to make setup easy.
• Cintel firmware updates are now managed by the Cintel Setup utility.
• Cintel SDK now fully abstracted from Desktop Video.
• KeyKode now available in frames as well as perforation count.
• General performance and stability improvements for all models.

Compatible Software Support

• DaVinci Resolve or DaVinci Resolve Studio.
• Any software that supports the Blackmagic Cintel SDK.

macOS Specific

Minimum system requirements for Cintel Software on Mac OS

• macOS 10.14 Mojave or later
• Any Mac with Thunderbolt 3 for Cintel 2 models.
• Any Mac with Thunderbolt 2 for Cintel 1 models.
• 4 GB of system memory.

Windows Specific

Minimum system requirements for Cintel Software on Windows

• Microsoft Windows 10 64-bit.
• Any Windows PC with Thunderbolt 3 or PCIe for Cintel 2 models.
• Any Windows PC with Thunderbolt 2 for Cintel 1 models.
• 4 GB of system memory.

Linux Specific

Minimum system requirements for Cintel Software on Linux

Basic system requirements:

• 64 bit x86_64 running Linux 2.6.18 or higher

Thunderbolt Hotplug Requirements

Thunderbolt devices cannot be plugged in hot on kernels earlier than 2.6.30.

Supported kernels older than 3.12 require an extra step after plugging the device in. You must tell the kernel to rescan the PCI bus using the following command:

# sudo sh -c 'echo 1 > /sys/bus/pci/rescan'

Kernel 3.12 and later support hotplug without the need for any extra steps.

Supported Distributions

• Ubuntu 17.10, 18.04
• Debian 8 - 9
• Fedora 27 - 28
• CentOS 6 - 7

Several different package formats are supplied:

• Native package (.deb) for Ubuntu and Debian based distributions.
• Native package (.rpm) for RedHat and Fedora based distributions.

Full release notes including installation instructions are available in the ReadMe.txt found in the downloadable tar archive.

Additional Information

Please check www.blackmagicdesign.com for additional information on third party software compatibility and minimum system requirements.

Some applications may use third party code under license. For details please refer to the included "Third Party Licenses.rtf" document.

© 2020 Blackmagic Design Pty. Ltd. All rights reserved. Blackmagic Design, Blackmagic, DeckLink, Multibridge, HDLink, Videohub, and "Leading the creative video revolution" are trademarks of Blackmagic Design Pty. Ltd., registered in the U.S.A and other countries.

Updated July 29, 2020.